Establishing Communication; No Interface Found Message; Looking For Interface Message - Crown AMB-5 User Manual

IQ–MSD Turbo 1.4 Advanced IQ System Software
/v

2.3 Establishing Communication

After the title screen has been displayed for a few seconds, it fades and the computer automatically attempts to
establish communication with an IQ interface and, if an interface was found, initiate a roll call. Figures 2.9 and 2.10
show the messages that may result if Turbo has trouble finding or communicating with an IQ interface:
In Figure 2.9, Turbo was unable to detect a CTS (Clear To Send) signal from the IQ interface. It then assumes that
no interface is present or that the interface is not properly connected. In Figure 2.10, Turbo thinks it found an IQ
interface and tries to communicate but cannot.
Causes Turbo to use a default VESA-compatible graphics driver. Turbo is usually able to
identify the computer's graphics controller and use it for optimum graphics performance. Use
this switch only if Turbo is unable to identify or use the graphics controller in your computer.
Fig. 2.9 No Interface Found Message
Fig. 2.10 Looking for Interface Message
2
Page 23