Monitoring An Equalizer; The Input/Output Level Bar Graphs On An Equalizer Gdm - Crown AMB-5 User Manual

IQ Address & Crown Bus Loop: The IQ address number you enter must match the physical IQ address
switch setting on the equalizer. The Crown Bus loop number must match the physical loop to which the equalizer
is wired.
On Line: The phrase "On Line" will appear in the upper right corner of the information area when an equalizer
is actively connected to and in communication with the IQ System.
Model, Location & Purpose: These three text lines are available for you to include relevant notes about
the unit. On the model line you can enter any text up to 13 characters. On the location and purpose lines you can
enter any text up to 19 characters. Only uppercase characters are allowed.

7.2 Monitoring an Equalizer

An equalizer can only be monitored from a graphics plate. A sample equalizer GDM (graphic display module) is
shown below in Figure 7.2.
Fig. 7.2 The Input/Output Level Bar Graphs on an Equalizer GDM
Notice in the lower right corner of the GDM that an input (I) and output (O) bar graph is shown for both Channel
A and B. Note: The actual appearance of your GDM will vary depending on the manufacturer of the equalizer.
Of course, you can always create your own custom GDM for an equalizer. See Section 3.9 for instructions on
creating a custom GDM.
Page 164
IQ–MSD Turbo 1.4 Advanced IQ System Software
Input/Output Level
Bar Graphs