Getting Started; Default Camera Username, Password, And Ports - Digimerge DNB14TL2 Instruction Manual

1. GETTING STARTED

The system comes with the following
components:
• 1 x Camera
• 1 x Mounting Screw Kit
• 1 x Mounting Plate
• 1 x Allen Key
• 1 x RJ45 Coupler
• 1 x RCA-to-BNC Test Cable
• 1 x Mounting Template
• 1 x Quick Start Guide
• 1 x Instruction Manual
• 1 x Software/Documentation CD
1.1 Default Camera Username,
Password, and Ports
Username: admin
Password: admin
Ports: 80 (HTTP), 30001 (Control/
Streaming), 8080 (RTMP), 554 (RTSP)
IP Address: DHCP Enabled by Default
(Router will automatically assign IP
address)
NOTE: Once you have completed the basic setup of the camera, it is
recommended to configure a static IP address. This will prevent the camera
IP address changing in the event of a power failure. For details, see "6.7.1
Local Network" on page 29.
Getting Started
Mounting Screw Kit:
• 4 x mounting screws
(PA4.0 x 35)
• 4 x anchors
• 4 x allen screws
• 1 x hinge screw
(pre-attached)
Mounting
Plate
RCA-to-BNC
RJ45 Coupler
Test Cable
Allen Key
1