Resetting To Factory Defaults - Digimerge DNB14TL2 Instruction Manual

7. RESETTING TO FACTORY DEFAULTS

Follow the steps below to revert all settings to factory defaults. The camera
must be connected to power to perform a factory reset.
1. Loosen the service compartment screw and open the service
compartment.
1
2. Press and hold the reset button for 5 seconds then release the button to
reset the camera to factory defaults.
2
3. Close the service compartment and tighten the service compartment
screw.
Service Compartment Screw
Reset button
Resetting to Factory Defaults
61