Table of Contents
Advertisement
3. Run the cables through the mounting plate. Align the TOP mark on the
camera base with the TOP mark on the mounting plate, rotate the
camera approximately 10° clockwise, and then rotate the camera
counterclockwise to slide the hinge screw into the notch on the mounting
plate. This will allow the camera to hang from the mounting plate while
you connect the cables.
3
TOP mark on
camera base
4. Connect the cables and then slide the camera to align the camera base
with the mounting plate. Attach the camera to the mounting plate using
the allen screws (4x).
4
Slide the camera to align the camera
base with the mounting plate
TOP mark on
mounting plate
Rubber
gasket
Camera Installation
Mounting plate notch
Insert allen
screws
7
Advertisement
Table of Contents
