Alarm Configuration; Disk Alarm - Digimerge DNB14TL2 Instruction Manual

Web Configuration
To change the language for the OSD and email alarms:
1. Click Device Configuration>Language.
2. Under Language, select the desired language then click OK to save
changes.

6.8 Alarm Configuration

Alarm Configuration contains the following sub-menus:

• Disk Alarm

• Motion Alarm
• Alarm I/O (Not supported)
• I/O Alarm Linkage (Not supported)
• Alarm Setting (Not supported)
6.8.1 Disk Alarm
The Disk Alarm page allows you to configure alarms if there is an issue with
the recording disk. You can configure a Disk Full Alarm or a Disk Error
Alarm. A Disk Full Alarm triggers an alarm when the recording disk is full or
exceeds a certain percentage. A Disk Error Alarm triggers an alarm if there
is an error accessing or writing to the recording disk.
Alarms can be viewed using the Alarm Manager in Syncro-V (see the
Syncro-V manual on the CD for details).
To configure Disk Alarms:
1. Click Alarm Configuration>Disk Alarm.
2. Check Disk Full Alarm to enable Disk Full Alarms.
36