Advertisement
SILENT ARMING /DISARMING
The system can be silently armed and disarmed as normal with but with no siren chirp. Turn ignition on and press the
#2 (Small) Button for about (3) seconds. You will hear (2) siren chirps. After the ignition is turned off, there will be no
siren chirps on arm/disarm. Repeat this procedure to enable chirps. (There will be 4 chirps when re-enabling)
ACTIVE RE-ARM PROGRAMMING
To enable this feature, Turn ignition on and press the #1 (Large) Button on the for about (3) seconds. (2) Siren chirps
will be heard when disabling this feature. Repeat procedure to enable. (1 siren chirp when enabling)
TRANSMITTER PROGRAMMING
1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3
short chirp.
2. Push the Program/Override Button for 5 seconds until the siren chirps (3) times. Release the button.
The system is now in programming mode.
3. Press Button #1 on new transmitter – siren will chirp to confirm programming. Repeat Step 3 within 5 sec. for up to
2 additional transmitters.
4. Turn off Ignition.
Note 1: If only one transmitter is being programmed, continue pressing button #1 until dash LED flashes goes out and
the system chirps to exit programming mode to prevent unauthorized codes and noise from entering the system.
Note 2: Programming mode is exited automatically after 5 seconds of last code transmission or once 3 new codes
have been programmed. The LED will flash (4) times indicating program mode exit.
ACTIVE ARMING
To arm the system, press the #1 (Large) button on the transmitter. You will hear a single siren chirp and the lights will
flash once. Doors will lock and the starter will be disabled if these optional features are installed. The red LED in the
vehicle will start flashing after 15 seconds. After a short delay to allow vehicle and electronics to stabilize the system
will be completely armed. If there is an intrusion into the vehicle or hard impact to the body the alarm will sound and
flash the lights for 45 seconds. After 45 seconds the system will automatically shut off and re-arm to continue to
protect the vehicle. If a door is left open the unit will cycle a second time and continue to protect the other non-
tampered zones. Note: To Arm/Disarm with a Soft (NIGHT) chirp press and release the #2 (Small) button.
DISARMING
To disarm the alarm and unlock the doors, press the #1 (Large) button on the transmitter. You will hear 2 siren chirps
and the lights will flash twice. Dash LED stops flashing.
PROGRAMMING
Note: System can learn up to 3 different codes max.
rd
time. (ON/OFF, ON/OFF, ON) You should hear (1)
OPERATION
Advertisement
