Start Up Flush - Global Water G5CT Operation Manual

Start-Up Flush
If you order our (ro) model you will receive a large white tank and a
separate box that containers the filter pack. Unpack both of these and set
them up near the cooler. Our (f) models do not have the tank. Now you
have to connect the water line to the filter pack which can be found on
water feed connections page. When the water runs off the last filter
connect one tube to the white tank and the other tube to the back of the
cooler.
To flush the filters disconnect the tube from the 2nd stage carbon filter
(circle in figure below) and place a cup or pan right underneath the hole
to catch water. Open ball valve inside the cooler 1/4-turn (handle in line
with tube is "on" and let water flow through filters into the bucket or pan
to push out air and carbon fines. When water runs clear, turn off ball
valve and re-connect the tube to the filter.
Turn on the water to the filter system by opening the ball valve inside the
cooler 1/4-turn (handle in line with tube is "on"). Check all connections
to assure there are no leaks.
Figure. 6 Filter configuration
13 | P a g e