Tank Flush - Global Water G5CT Operation Manual

Tank Flush

Flush tanks out by draining all water through the (1) drain
plug located on the back of the cooler and drain water through the
dispensing spigots. Fill and empty the tanks 3 times with the filtered
water, this ensures great tasting water. When the tank has filled
again with filtered water the cooler is ready to dispense water. You
may now turn on the Hot and Cold buttons on the back of the
machine. NOTE: You should always turn on the Hot and Cold
elements when they have water inside the tanks.
CAUTION. DO NOT TURN ON HOT OR COLD POWER CONTROLS
YET.
Remove the top cover of the cooler by removing 2 screws from back
of top cover. Pull the cover off, exposing the main tank. This model
uses a mechanical float valve to control flow to the tank. The unit
does not have to be plugged in to start water flow.
Water will flow into the ambient, cold and then the hot tank as well.
Let cooler tanks fill with the filtered water until full - about 1-hours
for the 'RO' version, about 10-15 minutes for the 'F' version.
Observe the water level when full, and see that water input to the
tank stops when it is full.
Figure. 7 Back view of the Cooler Water Connections Model G5CT
14 | P a g e