Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Global Water G4 Counter Top
Summary of Contents for Global Water G4 Counter Top
- Page 1 G4 Counter Top OPERATION MANUAL P a g e...
-
Page 2: Table Of Contents
Table of Contents Introduction…….…………………………………………………………………………………3 Receiving………….…………………………………………………………………………….…..4 Description Model G3 & G4……………………………………………………………...5/6 Water Production Flow Chart….…………………………………………………………..7 Positioning the Cooler………………….……………………………………………………..8 Water Cooler Connections…………….…………………………………………………….9 Feed Water Connection……………….…………………………………………………..10 Drain Connection……………………….………………………………………………….….11 EZ Connections………………………….……………………………………………………...12 Start Up Flush……………………………………………………………………………..….13 Tank Flush…………………………………………………………………………………..14 Cleaning and Maintenance…………….…………………………………………………. 15 Filter Replacement………………………….………………………………………………...16 Reverse Osmosis Membrane Replacement.……………………………………….. 17 Troubleshooting……………………………………….……………………………………..18 Specifications………………………………………….………………………………………..19 Warranty……………………………………………………….……………………………..…..19... -
Page 3: Introduction
The G4 model has two temperature faucets. The cold water is chilled around 44ºF and the hot water is heated at 180ºF. All Global Water models are manufactured and marked as “RO” or “F” assemblies. The “RO” assembly utilizes Reverse Osmosis water purification technology that produces pure and safe water from city or well water. -
Page 4: Receiving
Receiving the Cooler Unpacking Global Water products are shipped completely assembled and ready to operate. Remove the top of the box and slide the water cooler out and save the box and packing materials. Inspection Inspect the cooler for shipping damage. Look at the exterior panels to see if they have been dented or damaged. -
Page 5: Figure 2. Assembly Drawing, Model G4
Description Model G4 Counter Top Figure 2. Assembly Drawing Model G4 Counter Top P a g e... -
Page 6: Water Production Flow Chart
Water Production Flow Chart Figure 3. Water Flow Chart P a g e... -
Page 7: Positioning The Cooler
Positioning the Cooler It is not recommended to install this cooler in an area were water may cause severe or costly damage. 2) Do not position the cooler where it can be hit or bumped by vacuum cleaners or floor waxing machines. This can cause breaks in the waterline, connection fittings, and compressor tubing. -
Page 8: Water Cooler Connections
Water Cooler Connections When you receive the water cooler, the water connections on the back of the cooler have tube plugs in them. These tube sections must be removed before making all your connections. To remove the tube sections see Figure 7, “Disconnect”. The one-quarter inch plastic tubing should be used for making the Feed Water and Drain connections. -
Page 9: Feed Water Connection
Feed Water Connections P a g e... -
Page 10: Drain Connection
Drain Connection The drain connection applies to models with Reverse Osmosis, “RO.” The black drain line in the back (Figure 4) must be hooked to the drain line ahead of the normal sink water trap. See Figure 5 below. Place the two-part drain saddle on the drain pipe before the drain trap. -
Page 11: Ez Connections
EZ Connections The standard tubing connections on the water coolers are EZ connect fittings. Use tubing and follow the instructions below in Figure 7 to make the connections. If you cut the tubing, make sure it is a square cut, fits squarely in the fitting, and seals properly. Cut the tube square. -
Page 12: Start Up Flush
Start-Up Flush Open the right side panel to access filter assembly. Then, turn the water off at the ball valve on at the at the water connection. This brings water to the ball valve. Disconnect the tube from the second stage carbon filter (red circle in figure bellow), and place a cup or pan right underneath the hole to catch water. -
Page 13: Tank Flush
Tank Flush Flush tanks flush by draining all water through the drain plug located on the bottom of the cooler. The tanks drain water through the dispensing spigots. Fill and empty the tanks three times with the filtered water. This ensures great tasting water. When the tank has filled again with filtered water, the cooler is ready to dispense water. -
Page 14: Cleaning And Maintenance
Cleaning and Maintenance Sanitize Fill the main water tank with water. Add one to two teaspoons of liquid chlorine bleach. Let stand for five to 10 minutes. Drain the water, then let water from filters refill tank and drain a second time. Remember to drain from dispensing spigots also. -
Page 15: Filter Replacement
Filter Replacement The filter elements must be replaced at regular intervals to maintain the quality of the water. The G4CTF have two stages of mechanical filtration. The first stage is the 5-micron sediment filter. The second stage is the activated carbon filter. -
Page 16: Reverse Osmosis Membrane Replacement
Reverse Osmosis Membrane Replacement (every three years) RO versions (RO) a) Use the same procedure as above sec a-c. b) Remove the RO stage from the clips. Disconnect the white tubing from the RO housing cap. c) Remove the cap from the housing by unscrewing it. d) Using a pair of pliers, remove the RO element from the housing by grasping the tube end and pulling it out. -
Page 17: Troubleshooting
Trouble Shooting Guide PROBLEM CAUSE SOLUTION No Power No electric current Make sure the cooler is flowing. plugged in and check for improper connections. Cold Water not cold The cooler is placed too Provide a minimum of enough close to the wall. a five inch space between wall and back Wire Condenser on... -
Page 18: Specifications
Specifications Model No. G4CT Voltage/Frequency AC110V (L)18 Dimensions (W)11 (H)16 Weight (empty) 42lb. Hot Water Tank .5 gal. Capacity Cold Water tank .5 gal. Capacity Power Water: Consumption 500W Cold Water: 100W Electric Power Cord 6Ft. Length 18 | P a g e... -
Page 19: Warranty
Warranty All Global Water products are warranted to be free from defects in materials and workmanship under normal use within the condition of operation listed for a period of one year from the date of purchase. The compressor has a 3-year warranty. - Page 20 Tel. (866) 289-7518 Fax (786) 207-2570 E-mail Orders@bluline.com Cleaner, Healthier Water www.Bluline.com 20 | P a g e...