Table of Contents
Advertisement
2-6 General Description
8
ID switch
Press this switch to turn on or off the ID lamp.
9
ID lamp (blue)
The lamp is intended to identify the CPU blade in the system. The lamp is lit by a switch or
software command.
When the recognize command is received from software, the lamp blinks. If you press the ID
switch, the lamp goes on.
You may use the remote control feature of EXPRESSSCOPE Engine 2 (BMC) to perform the
same operation as using the ID switch on the server.
10
Eject lever
Pull the lever to remove the CPU blade from the Blade Enclosure.
11
SUV connector
This connector sends or receives various signals.
The K410-150(00) SUV cable is connected to this connector.
Advertisement
Table of Contents
