Table of Contents
Advertisement
7.
Select the [LSI MegaRAID SAS RAID Controller Driver (Server 2003 32-bit)] and press
Enter.
The screen of Step 5 is displayed. Go to Step 8.
8.
<If the N8403-018 FibreChannel Controller is connected>
Press S.
The screen of Step 6 is displayed. Press Enter, and go to Step 9.
<If the N8403-018 FibreChannel Controller is not connected>
Press Enter, go to Step 10.
9.
Select the [Emulex LPX000 PCI Fibre Channel HBA] and press Enter.
IMPORTANT:
proceed.
The screen of Step 5 is displayed.
Press Enter, go to Step 10.
10.
When the following message is shown, press Enter to start "Welcome to Setup".
11.
When the installation of Windows Server 2003 has finished, the system reboots
automatically.
The following messages may be displayed. Press S to
The driver you provided seems to be newer
than the Windows default driver.
Windows already has a driver that you can use
for "Emulex LPX000 PCI Fibre Channel HBA"
Unless the device manufacture prefers that
you use the driver on the floppy disk, you
should use the driver in Windows.
Installing the Operating System B-29
Advertisement
Table of Contents
