Identity Code; Configuring The Interface - Crestron TPS-G-TPI Operation Manual

®
Crestron Isys TPS-G-TPI
QM Network Topology
QM Network Topology with TPS-G-TPI Acting as an Endpoint and a Transmitter
Origination Points
QM
QM-WMC
QM
QM-WMC
Operations Guide – DOC. 6445
NOTE: In the case of the QM 2 input port, the maximum cable length will vary. See
the QM Input # 2 Maximum Cable Length table on page 10.
When connecting multiple QM devices, the route between a QM origination point
(transmitter) and a QM endpoint (receiver) cannot have more than two midpoints
(e.g., QM-MD7x2 or other QM switchers). Refer to the following diagram when
configuring a QM network.
The TPS-G-TPI is not a switcher, but a QM transmitter. Therefore, even when
designated as the endpoint from two midpoint switchers, the QM output of the
TPS-G-TPI can become another transmitter sending RGB video at the touchpanel's
native resolution and aspect ratio. Refer to the following diagram.
Midpoints
QM
QM-MD7x2 QM-MD7x2

Identity Code

All equipment and user interfaces within the network require a unique identity code
(Net ID). These codes are two-digit hexadecimal numbers ranging from 03 to FE
(Net ID 02 is reserved for control processors). The Net ID of each unit must match
an ID code specified in the SIMPL Windows program. The Net ID is set using the
internal setup menu (refer to "Interface Menu" on page 16). The Net ID may also be
changed using Crestron Toolbox (refer to "Establishing Communications" on page
41).

Configuring the Interface

NOTE: In order to configure the TPS-G-TPI interface, power (supplied via Cresnet)
and a connection to an external touchpanel or other video device are required. Refer
to "Hardware Hookup" on page 31 for details.
G-Series Touchpanel Interface
QM
TPS-G-TPI
This TPS-G-TPI acts
as both an endpoint
for signals from the
QM-WMC origination
points AND a QM
transmitter to the
QM-RMCRX-BA.
®
G-Series Touchpanel Interface: TPS-G-TPI ¥ 13
Isys
Endpoints
QM
QM-RMCRX-BA
This QM-RMCRX-BA
does not violate the
two-midpoint rule as it
is receiving an RGB
signal from the
TPS-G-TPI transmitter.