Crestron TPS-G-TPI Operation Manual page 52

G-Series Touchpanel Interface
®
48 ¥ Isys G-Series Touchpanel Interface: TPS-G-TPI
Use the following instructions to create the IP table.
1. Select Functions | IP Table Setup from the Toolbox menu bar.
"IP Table" Window
2. If the interface already has an IP table, it is displayed at the top of the
window.
3. Click Add Entry to add a new IP table entry or select an existing IP entry
from the list and click Modify Entry. Up to 252 entries can be listed on a
interfaces IP table. Click Remove [Del] to remove a selected IP entry or
click Clear List to remove all of the entries from the IP table.
NOTE: IP table entries that have not yet been sent to the device are listed in
red.
4. Click Load From File... to browse for a saved IP table.
"Open" Window
5. To enter a new IP ID, select the hexadecimal IP ID of the control system
from the IP ID list. The IP ID of the control system must match the IP ID
that is specified for the interface in the SIMPL Windows program.
®
Crestron Isys TPS-G-TPI
Operations Guide – DOC. 6445