Crestron TPS-G-TPI Operation Manual page 53

®
Crestron Isys TPS-G-TPI
Operations Guide – DOC. 6445
"IP Table Entry" Window
NOTE: All IP table entries are set as Master and cannot be changed.
6. In the IP Address/Hostname field, enter the static IP address of the control
system, or if the control system is DHCP-enabled, its fully qualified domain
name. After entering all of the information, click OK to add the device to
the IP table.
7. Repeat this procedure for all the control systems that will control the
interface.
8. Click Save To File... on the "IP Table" window to save this IP table to the
PC.
"Save As" Window
9. Once all of the control systems have been listed, click Send to Device on
the "IP Table" window to upload the IP table to the interface. The interface
will reboot and all of the table entries will be listed in black.
NOTE: The control system IP table for the TPS-G-TPI must have a
loopback entry of 127.0.0.1 to indicate a gateway.
NOTE: When an IP table is sent to the interface, the previously loaded IP
table is overwritten.
Isys
G-Series Touchpanel Interface
®
G-Series Touchpanel Interface: TPS-G-TPI ¥ 49