Configuring the Handset
You can configure the phone using one of two methods:
1. The Features and User settings menus on the phone.
2. The WebUI, which you access using your Internet browser.
This section describes settings you can change using your
handset. For information about settings you can change on the
WebUI, see "WebUI" on page 58.
The system administrator can configure additional settings,
including Network settings, Provisioning, and the PIN code by
using the Admin settings menu. For more information about this
menu, see the VDP650 Administrator and Provisioning Manual,
businessphones.vtech.com
available at
Setting do not disturb
When Do Not Disturb (DND) is on for an account, calls to that account will be
rejected.
To turn DND on or off:
1. Press MENU.
2. Press q to scroll to Features and press SELECT.
3. With DND highlighted, press SELECT.
4. Press p or q to select which account DND should apply to*,
then press SELECT.
5. Press p or q to choose On or Off.
6. Press
SET
* Note that DND will apply to all handsets assigned the account.
Setting call forwarding
Calls can be forwarded to another phone number always, only when busy, or
after a set number of rings.
To set call forward:
1. Press MENU.
2. Press q to scroll to Features and press SELECT.
3. Press q to scroll to Call forwarding and press SELECT.
4. Press p or q to select which account Call forward should
apply to*, then press SELECT.
5. Press p or q to choose the desired option:
•
Always
•
Busy
•
No answer
to save.
.
48