Table of Contents
Advertisement
Message
A connection with the FTP/
Failed To Connect
SMTP/POP3/SMB/SNTP
server, or USB memory device
####
has failed.
The assigned file names range
from SIG000101 to
SIG999901. If the file name
assignment passes SIG999901,
File Over
the naming starts over from
SIG000101. If the name of the
new is the same as an existing
file for the same destination, the
new file cannot be stored.
You can only scan up to 99
Page Over
pages at a time.
Data sent from the machine has
#### Server Error
not been stored on the
FTP/SMB server.
The SMTP server's memory
SMTP Server Full
reached capacity during e-mail
transmission.
Memory Overflow
The machine's memory became
full while scanning.
1: TX 2: Cancel
The Scan to USB function failed
USB Flash Disk Full
because there was not enough
memory on the USB flash disk.
Causes
If the problem involves the FTP/SMB
server, check the [Edit Network Scan
Destination] setting in Smart Organizing
Monitor.
If the problem involves the SMTP/POP3/
SNTP server, check the [Server
Properties...] setting in Smart Organizing
Monitor.
If the problem involves the USB flash drive,
check that it is a supported model, and
then reinsert it.
Remove or rename the existing file of the
same name.
Set the number of pages to 99 or fewer.
Check the [Edit Network Scan Destination]
setting in Smart Organizing Monitor.
Check the SMTP server setting.
Reduce the number of pages or send the
file at a lower resolution.
Send the file at a lower resolution.
Use a USB flash disk with enough memory.
Error and Status Indicate on the Control Panel
Solutions
185
Advertisement
Table of Contents
