Ricoh SP 203 SF Operating Instructions Manual page 186

10. Troubleshooting
Message
Type Mismatch:
Tray1
Press Start or Stop
Scan Disconnected
Cannot Connect
#### Server
Cannot Obtain IP
#### Server
Communication Error
####
Invalid Password
#### Server
184
Causes
The specified paper type of the
file does not match that of the
paper loaded in Tray 1.
The USB cable or Ethernet cable
was disconnected while
scanning from a computer.
The connection with the FTP/
SMTP/POP3/SMB/SNTP
server was lost while sending or
receiving data.
The machine cannot obtain an
IP address from the FTP/SMTP/
POP3/SNTP server.
The connection with the FTP/
SMTP/SMB/SNTP server, or
USB memory device was lost
while sending or receiving data.
The password entered to access
the FTP/SMTP/POP3/SMB
server is invalid.
Solutions
Press the [Start] key to begin printing, or
press the [Stop/Clear] key to cancel the
job.
If [Auto Continue] is set to [0 sec.], no error
message appears.
Reconnect the USB cable or Ethernet cable
properly, and then try the operation again.
If the problem involves the FTP/SMB
server, check the [Edit Network Scan
Destination] setting in Smart Organizing
Monitor.
If the problem involves the SMTP/POP3/
SNTP server, check the [Server
Properties...] setting in Smart Organizing
Monitor.
If the problem involves the FTP server,
check the [Edit Network Scan Destination]
setting in Smart Organizing Monitor.
If the problem involves the SMTP/POP3/
SNTP server, check the [Server
Properties...] setting in Smart Organizing
Monitor.
If the problem involves the FTP/SMB
server, check the [Edit Network Scan
Destination] setting in Smart Organizing
Monitor.
If the problem involves the SMTP/SNTP
server, check the [Server Properties...]
setting in Smart Organizing Monitor.
If the problem involves the USB flash drive,
check that it is a supported model, and
then reinsert it.
For future reference, make a note of the
correct password and keep it safe.