How To Create The Program - Crestron STX-1600C Operation Manual

CRESTRON
"MUTED" is sent to the touchpanel. When the ST-VC is unmuted, a space is sent to
the touchpanel.
Block Diagram of STX-1600C

How to Create the Program

Configuration Manager
Use the Configuration Manager workspace (Project | Configure System) in SIMPL
Windows to select and configure all the devices that need to be included into the
system. For this example, add a CNRFGWX and ST-VC to the system. The NET ID
of each device must be set as shown below and on the next page.
NOTE: SIMPL Windows v1.21.04 or later is required to program the control
system containing a STX-1600C touchpanel. If using an earlier version of SIMPL
Windows, Crestron recommends a SIMPL Windows and operating system upgrade.
The latest version can be obtained from the Software Downloads page of Crestron's
website (www.crestron.com). New users are required to register in order to obtain
access to the FTP site.
Network System View of CNRFGWX in SIMPL Windows' Configuration Manager
Series STX Touchpanels • 17
Operations Guide - DOC. 5716A