Setting Analog Audio Connections To An Av Amplifier Or Receiver - Pioneer DV-636D Operating Instructions Manual

MPEG Out
This player is capable of outputting the MPEG digital
bitstream. When the player is connected to an AV
component that has a built-in MPEG decoder, select the
[MPEG] setting. Otherwise, select [MPEG 3 PCM] to
convert the digital signal to the PCM signal, the digital
signal output from a CD.
Audio1
Dolby Digital Out –
96kHz PCM Out – 96kHz 3 48kHz
Change MPEG audio output mode
Settings: MPEG
MPEG 3 PCM*
Digital Out
Expert
Depending on your preferences and the type of
connections made, you may opt not to have the digital
audio signal output at all. When this setting is set to
[Off] there is no signal output from the digital audio
output jacks.
Make changes to the [Digital Out] setting in the Setup
screen Audio 1 menu in the [Expert] menu mode (page 30).
Audio1
Dolby Digital Out –
96kHz PCM Out – 96kHz>48kHz
Settings: On (Digital bitstream is output)*
Off (Digital bitstream is not output)
32
Audio2 Video Language General
Dolby Digital
DTS Out – Off
MPEG Out
MPEG
3 PCM
MPEG
Move
SETUP Exit
*
Factory setting
Audio2 Video Language General
Dolby Digital
Off
DTS Out –
MPEG Out – MPEG 3 PCM
On
Digital Out
Off
Move Exit
SETUP
* Factory setting
Setting Analog Audio
Connections to an AV Amplifier or
Receiver
This player is capable of both 2 channel stereo and 5.1
multichannel surround sound audio output. Use this
setting to select which analog outputs are connected to
an AV component.
Make adjustments in the [Audio Out] setting in the
Setup screen Audio 2 menu.
Audio1 Audio2 Video
Virtual Surround –
Audio DRC – Off
Audio Out
Speaker Setting
Setting up audio output
Move
Settings: 2 Channel*
5.1 Channel
Notes
• This setting can also be changed by using 5.1 CH MODE
on the front panel. However, this button does not work
when the "GUI" indicator is lit.
• When [5.1 Channel] is selected, the front right (R) and left
(L) audio channels are output from the AUDIO OUT (2 CH)
jacks.
• If the center or surround components are not recorded on
the disc, there will be no output from the CENTER or
SURROUND output jacks. This is not a malfunction.
Speaker channels can be verified in the program format
indicators in the display.
• When [5.1 Channel] is selected at this setting and [Dolby
Digital 3 PCM] is selected in the [Dolby Digital Out]
setting in the Setup screen Audio 1 menu, there is no
audio output from the digital output jacks.
Language General
Off
2 Channel
5.1 Channel
SETUP Exit
*Factory setting