Installing The Center Speaker - Pioneer AVH-P7490DVD Owner's Manual

Installing the Center Speaker

Precaution:
• Do not dismantle the speaker system by removing all the screws.
• If the speaker terminals are wired incorrectly, low pitched sounds will not be reproduced fully.
• Be sure to use a speaker load impedance of 4 ohm and keep peak maximum music power
below 45 W.
1. Make some marks for the positions of the screws and velcro
tape using the mounting template.
2. Secure the center speaker.
169
Tapping screw
(4 × 40 mm)
Mouting template
Cut the template along
the dotted line before use.
Hexagonal wrench
Velcro tape (60 × 60 mm) (2-3/8 × 2-3/8 in.)
(rough surface)
Velcro tape (60 × 60 mm) (2-3/8 × 2-3/8 in.)
(soft surface)
Drill 2 to 2.5 mm (1/8 in.) diameter holes.
Marking only.