Weber Summit Gold D 42080 Owner's Manual page 28

2) Mix soap and water.
3) Turn on the cylinder valve.
4) Check for leaks by wetting the fitting with the soap and
water solution and watching for bubbles. If bubbles
form, or if a bubble grows, there is a leak.
If there is a leak, turn off the gas and tighten the fitting. Turn
the gas back on and recheck with the soap and water
solution.
If leak does not stop, Contact the Customer Service
Representative in your region using the contact information
sheet provided with your manual. Do not use the barbecue.
5) When leak checking is complete, turn gas supply OFF
at the source and rinse connections with water.
WARNING : The gas connections of your Summit
gas grill have been factory tesated. We do however
recommend that you leak check all gas connections
before operating your Summit
Remove control panel
Part required: Phillips Screwdriver.
Remove the burner control knobs (1). The screws (2) need
to be removed from the control panel (3) before the control
panel is removed from the grill.
(1)
Put your fingers under the front edge of the control panel
and lift off.
Gas Instructions
®
®
gas grill.
(2)
(3)
Completely remove the control panel (4) from the cooking
box assembly exposing the valves, burners, igniter, and
manifold.
(2)
Remove the Front Panel by sliding the panel up and out of
the slots.
28
(4)