Gas Instructions - Weber Summit Gold D 42080 Owner's Manual

Purchase a full cylinder of gas from your gas dealer
The cylinder must always be installed, transported and
stored in an upright position. Never allow the cylinder to
drop or be handled carelessly. Never store cylinder
where temperatures can exceed 51° C (too hot to hold
by hand). For example, do not leave the cylinder in your
car on hot days. (See Section "Safe handling tips for LP
gas".)
Mounting the Cylinder
You will need: Gas supply cylinder (full) and Cylinder
Hanger
Place the cylinder so the valve opening faces to the rear of
the barbecue. Hold the hanger and tilt the cylinder so the
two bent supports of the hanger are located underneath the
cylinder base flange. Adjust the length of the belt to the
cylinder and snap ends together.
Lift and place the cylinder hanger on the cylinder bracket as
shown. (1)

Gas Instructions

Hose to manifold connection
The hose connects to the manifold, which screws into
the manifold fitting(1) or pushes onto the manifold push
on fitting(2).
(1)
Connecting the Liquid Propane
Cylinder
closed. Close by turning valve clockwise.
Do not use an open flame to check for gas
leaks. Be sure there are no sparks or open
flames in the area while you check for leaks.
Sparks or flames will result in a fire or
explosion that can cause serious bodily
injury or death, and damage to property.
You will need: LP cylinder, a soap and water solution and
a rag or brush to apply it.
1) Connect the hose and regulator.
The regulator illustrations shown in this manual, may not be
similar to the one you are using for your barbecue, due to
different country or region regulations.
Some regulators push ON to connect, and pull OFF to
disconnect, others have a nut that has a left-hand thread
that connects to the cylinder valve. Follow specific regulator
connection instruction.
Position the regulator so that the vent hole faces down.
27
(1)
WARNING: Make sure that the LP cylinder valve is
DANGER
(2)