Contacting Fluke Networks; Safety Information - Fluke TS 100 PRO User Manual

TS100 PRO Cable Fault Finder
Users Guide

Contacting Fluke Networks

www.flukenetworks.com
support@flukenetworks.com
+1-425-446-5500 or 1-800-283-5853

Australia: 61 (2) 8850-3333 or 61 (3) 9329 0244

Beijing: 86 (10) 6512-3435

Brazil: 11 3759 7600

Canada: 1-800-363-5853

Europe: +31-(0) 40 2675 600

Hong Kong: 852 2721-3228

Japan: 03-6714-3117

Korea: 82 2 539-6311

Singapore: +65-6799-5566

Taiwan: (886) 2-227-83199

USA: 1-800-283-5853
Visit our website for a complete list of phone numbers.

Safety Information

The following IEC symbols are used either on the tester
or in the manual:
Warning: Risk of personal injury. See the

manual for details.
Caution: Risk of damage or destruction to
equipment or software. See the manual
for details.
Warning: Risk of electric shock.

Risk of damage to equipment from static

discharge.
Earth ground

2
Conformité Européenne. Conforms to

relevant European Union directives.
Meets safety requirements of North

America
Do not put products containing circuit

boards into the garbage. Dispose of
circuits boards in accordance with local
regulations.
 Warning
To avoid possible fire, electric shock or
personal injury:

Before you use the tester, carefully read all of the
safety information and instructions in this manual.

Do not connect this equipment directly to a mains
electrical supply. This equipment conforms to the
safety measurement standard for equipment
without a rated measurement category.

Do not connect the tester to power sources. If the
VOLTAGE LED is on, immediately disconnect the
tester from the cable.

Do not use the tester to test cables that may have
hazardous voltages present. When the tester
indicates the presence of high AC or DC voltages,
carefully disconnect immediately to prevent any
personal injury. Be careful when you make
connections to cables.

Do not touch voltages > 30 volts AC RMS, 42 volts
AC peak, or 60 volts DC.

Do not connect the tester to voltages higher than
the maximum specified by the measurement
category (CAT) rating of the lowest-rated
individual component of the tester, the test leads,
or any accessory.

Do not use the tester around explosive gas or
vapor or in damp or wet environments.
