Vision Fitness 100 Series Calibration Manual

Calibration Guide
100 Series
Model: R2150 (RB111), E3100 (CB125)

STEP 1 ENTER ENGINEERING MODE

•Press and hold the
"UP ARROW"
buttons simultaneously for five seconds.
ARROW"
• You will hear a series of beeps and the display will read
" " U U S S E E R R S S E E T T " " .

STEP 2 SELECTING ENGINEERING MODE

•Press the
"UP ARROW"
to view the various Engineering Modes.
• Press to select the desired mode.
"ENTER"

STEP 3 USER SET MODE

•Setting Default Time
- The top left window will be flashing the default time.
- Use the
"UP ARROW"
buttons to set default time.
- Press and hold
"ENTER"
seconds to save the default time.
- Press to go to Default Level.
"ENTER"
• Setting Default Level
- The bottom right window will be flashing the default
level. Use the
"UP ARROW"
buttons to set default level.
- Press and hold
"ENTER"
seconds to save the default level.
• Accumulated Time
- The center left feedback window will display
accumulated hours of use.
• Accumulated Distance
- The center right feedback window will display
accumulated distance in miles or kilometers.
• To EXIT USER SET MODE press and hold
approximately three seconds.
Date of last revision: 9.06
and the
"DOWN
or buttons
"DOWN ARROW"
or
"DOWN ARROW"
for approximately three
or
"DOWN ARROW"
for approximately three
for
"START"
INSTRUCTIONS
1. Choose PROGRAM using arrows, press ENTER
2. Choose TIME using arrows, press ENTER
3. Choose WEIGHT using arrows, press ENTER
4. Choose LEVEL using arrows, press ENTER
5. Press START to begin
Press START at any time for EASY START
PAUSE • HOLD TO RESET
1
CAUTION! CAUTION!
IF YOU EXPERIENCE CHEST PAINS, DIZZINESS, OR
SHORTNESS OF BREATH, STOP EXERCISING IMMEDIATELY
AND CONSULT YOUR PHYSICIAN BEFORE CONTINUING.
ENTER
START RESISTANCE
BIKE.CALIB.RB111.CB125.REV1