Vision Fitness 1500 Series Calibration Manual

Calibration Guide
1500 Series
Model: X1500 (EP145)
This guide will assist you in entering the Engineering Mode of the console to view and/or change the following variables:
• Console Tests
- LCD display testing
• Machine Accumulated Variables/ ECB testing
- Total Time
- Total Distance
- ECB test
• Software Version and Measurement Variables
- Software version test
- Miles or Kilometers
• Default Time
• Default Level
• Setting the console for:
- Miles or Kilometers
- Bike or Elliptical
ENTER ENGINEERING MODE
• Press and hold the
"UP"
simultaneously for approximately three seconds.
• You will hear a series of beeps and the display will read
" " E E N N G G 1 1 " " . You are now in ENGINEERING MODE.
• Use the and
"UP" "DOWN"
five Eng mode subgroups. Press
ENGINEERING MODE SUBGROUPS
• Eng1 (LCD Display testing)
- Press and
"UP" "DOWN"
- To exit, press
"PAUSE"
• Eng2 (Total Time, Total Distance, ECB test)
- Press and
"UP" "DOWN"
- Lower left display shows location of ECB brake.
- Left center display shows the accumulated hours of use on machine.
- Right center display shows the accumulated distance in miles or kilometers on machine.
- To exit, press
"PAUSE"
• Eng3 (Software version test, MI or KM)
- Matrix display shows Miles or Kilometers.
- Lower left display shows Bike or Elliptical mode.
- Left center display shows software version.
- To exit, press
"PAUSE"
Date of last revision: 9.06
and buttons
"DOWN"
buttons to scroll through the
to select mode.
"ENTER"
buttons to test LCD displays.
.
buttons to test brake movement through cycle.
.
.
1
ELLIPTICAL.CALIB.EP145.REV1