Advertisement
Paper Dispenser (#058-610)
The paper dispenser can be mounted on the head end of
the table.
Installing the Paper Dispenser:
1. Raise completely the Fowler back section of the table.
2. Using a 7/16" wrench, remove the two 1/4-20" hex head
screws from under one side of the head end of the
Fowler back cushion.
3. Position the appropriate paper dispenser mounting
bracket on the bottom of the Fowler back cushion so
that the paper dispenser rod post faces up toward the
outside top corner of the cushion. Ensure the pre-drilled
screw holes align with the screw holes from step 2.
4. Using a 7/16" wrench, install the two 1/4-20" hex head
screws removed in step 1 through the dispenser mount-
ing bracket and tighten to secure the paper dispenser in
place.
5. Repeat steps 1 – 4 for the opposite side.
6. Place a role of paper on the paper dispenser rod and
install the rod between the brackets. Press in on either
spring-loaded end of the paper dispenser bar in order to
slide it into the brackets.
7. Pull the paper over the cushions.
8. Pull unused paper through the cutter strap mounts at
the foot end of the table.
9. After use, cut the paper and dispose of used portions.
Figure 6. Installing the paper dispenser.
- 9 -
Advertisement
