Table of Contents
Advertisement
iMedia FlipTop Computer Center
Crestron IM-FTCC-B
Applications
®
The IM-FTCC-B/IMI-FTCC-B is part of the Crestron
iMedia line of network
devices, room control systems and signal routing solutions. The line of IM
devices includes receivers and transmitters. Consult the Crestron website for a
complete and current listing of the iMedia product line.
NOTE: Composite video output of the IM-RXV1 and IM-RXV3 will not be
displayed when using the IM-FTCC-B/IMI-FTCC-B.
The iMedia FlipTop Computer Center is designed to install flush in a tabletop
surface to provide a convenient and low profile interface solution. Beneath the
flip-top lid, a recessed compartment contains easy pull-out RGB and audio
cables to facilitate the connection of a single computer source. The cables stow
neatly within the compartment when not in use. Excess cable simply drops out-
of-sight below the box through grommeted holes provided in the bottom plate.
An additional hole is available to accommodate a third-party LAN cable if
needed. A cutout template is included.
®
NOTE: The IM-FTCC-B and IMI-FTCC-B are not Cresnet
devices.
This device uses iMedia (IM) technology utilizing a single CresCAT-IM cable
to transmit computer RGB and stereo audio signals to a single projector or
plasma display. A typical XGA signal (1024 X 768 pixels at 60 Hz) can be
transmitted up to 84 feet using iMedia, while higher resolutions up to
1600 x 1200 can be handled over shorter distances. Audio is transmitted
digitally at 20-bit, 48 kHz resolution. To facilitate connection of audio, video,
and computer equipment, all media, power and control signals are routed via a
single CresCAT-IM cable for an uncomplicated installation.
The IM-FCC-B is part of a family of compatible iMedia devices, all capable of
working together to put on simple to complex media presentations. The
following diagram shows the interconnections.
2 • iMedia FlipTop Computer Center: IM-FTCC-B
Operations & Installation Guide - DOC. 6349A
Advertisement
Table of Contents
