Product Certifications; Packaging And Supplied Accessories; Transport And Handling - Ariston NUOS Manual

1.4 Product certifications

The CE marking of the appliances attests its conformity to the following EC Directives, of which it satisfies the
essential requisites:
- 2006/95/EC on electrical safety (EN/IEC 60335-1; EN/IEC 60335-2-21; EN/IEC 60335-2-40);
- 2004/108/EC on electromagnetic compatibility (EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3);
- RoHS2 2011/65/EU on restriction of use on certain hazardous substances in electrical and electronic equipment
(EN 50581).
- Commission Regulation (EU) no. 814/2013 on ecodesign (no. 2014/C 207/03 - transitional methods of
measurement and calculation)
Verification of performance is carried out through the following technical regulations:
- EN 16147;
- CAHIER DE CHARGE_103-15/B_2011 Chauffe-eau Thermodynamiques pour la marque NF élettricitè
performance;
- 2014/C 207/03 - transitional methods of measurement and calculation
This product complies with:
- REACH Regulation 1907/2006/EC;
- Commission Delegated Regulation (EU) no. 812/2013 (labelling)

1.5 Packaging and supplied accessories

The appliance is anchored to a wooden pallet and is protected with polystyrene top cover, wooden edge protectors,
and external cardboard; all the materials are recyclable and eco-compatible.
The following accessories are included:
- Belt for handling the water heater (to be removed once the product is installed);
- Connection pipe for condensation water;
- One 3/4" dielectric coupling and joint;
- Instruction manual and warranty documents;
- Energy label and product fiche;
- 2 adapters for Ø150 and Ø160 ducts.

1.6 Transport and handling

Upon delivery of the product, check that the latter has not been damaged during transport and that no signs of
damage appear on the packaging. In the event of damages, immediately notify any claims to the forwarder.
WARNING! The appliance should be handled and stored in a vertical position. The product may be handled in
a horizontal position only for short distances, while resting on the rear end indicated; in this case, wait at
least 3 hours before starting the appliance once it has been correctly repositioned in a vertical position
and/or installed; this is to ensure that the lubricating oil inside the refrigeration circuit is suitably distributed
and to avoid damages to the compressor.
The packaged appliance may be handled either manually or with the aid of a forklift truck, while ensuring that the
above indications are observed. It is advisable to keep the appliance in its original packaging until installing it in its
chosen location, particularly when construction work is under way on-site.
Upon removing the packaging, check whether the appliance is intact and that no parts are missing. In the event of
defects or missing components, notify the dealer within the time limits specified by the law.
WARNING! Keep the packaging elements out of the reach of children, as they are potentially dangerous.
When transporting or handling the appliance after the initial start-up, observe the aforementioned indication
concerning the allowed tilt angle and ensure that all water has been drained from the tank. Should the original
packaging be missing, provide an adequate protection for the appliance to prevent any damages, for which the
manufacturer shall not be held liable.
Heat pump water heater – GENERAL INFORMATION
63