Product Certifications; Packaging And Supplied Accessories; Transport And Handling - Ariston Wi-Fi Manual

Hybrid electric water heater (WiFi model) – GENERAL INFORMATION
1.4

Product certifications

The CE marking applied to the appliance certifies that it conforms with the essential requirements of the following
European Directives:
2014/35/EC on electrical safety LVD (EN/IEC 60335-1; EN/IEC 60335-2-21; EN/IEC 60335-2-40);
-
2014/30/EC on electromagnetic compatibility EMC (EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3);
-
RoHS2 2011/65/EU on restrictions on the use of particular hazardous substances in electrical and electronic
-
appliances (EN 50581).
(EU) Regulation no. 814/2013 relating to ecodesign (no. 2014/C 207/03 - transitional methods of measurement
-
and calculation)
The performance inspection is carried out according to the following technical standards:
EN 16147;
-
2014/C 207/03 - transitional methods of measurement and calculation
-
This product conforms to:
REACH Regulation 1907/2006/EC;
-
(EU) Regulation no. 812/2013 (labelling)
-
RED Radio Equipment Directive: ETSI 301489-1, ETSI 301489-17
-
The Conformity Declaration is available at internet site: http://www.aristonthermo.com/en/download-area
1.5

Packaging and supplied Accessories

The appliance is protected by expanded polystyrene foam pads; all materials are recyclable and environmentally
friendly.
The following accessories are included:
Instruction manual and warranty documents;
-
Nr.2 Quick start guide;
-
No. 2 x 1/2" Dielectric unions;
-
Overpressure device (8 bar);
-
Condensation water outlet connection pipe and outlet water safety valve;
-
Condensation drainage pipe;
-
No. 2 x Screws, no. 2 x plugs;
-
Energy efficiency label and product data sheet.
-
1.6

Transport and handling

Upon delivery of the product, check that the latter has not been damaged during transport and that no signs of damage
appear on the packaging. In the event of damages, immediately notify any claims to the forwarder.
WARNING! The unit must be handled and stored in the upright position, without
exceeding a maximum incline of 45° to ensure there is a suitable distribution of the oil in
the refrigerant circuit and to prevent damage to the compressor. (see fig.1)
The packaged unit can be moved by hand or with forklift trucks, taking care to respect the directions above. It is
recommended to keep the product in its original packaging until you install it in the selected area, particularly in the case
of a construction site.
After unpacking, check for accuracy and completeness of the supply. In case of non-compliance, please contact the
seller, taking care to make a communication within the law.
WARNING! Keep the packaging elements out of the reach of children, as they are potentially dangerous.
When transporting or handling the appliance after the initial start-up, observe the aforementioned indication concerning
the allowed tilt angle of the unit, and ensure that all water has been drained from the tank. If the original packaging
missing provide an adequate protection for the appliance to prevent any damages, for which the manufacturer shall not
be held liable.
39