Storage And Printing Of Valve Data - oventrop OV-DMC 2 Operating Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

Storage of valve data

The menu "Store Measurement" offers the possibility to store measurements.

Apart from "name", "group" and "number", the valve type, valve size, preset-

ting, differential pressure and flow rate are stored. This data can be printed via

the USB interface.

Name

The menu option "name" allows the entry of up to 8 alphanumerical signs (0-9,

A-Z, a-z). Figures are entered by pressing the corresponding keys on the key-

board. Letters are produced by using the keys

moves you either upwards (A, a, B, b...) or downwards (Z, z, Y, y...) in the

alphabet.

Having reached the required letter, the cursor is moved one position to the right

by using the key

. Then press the key "OK" to conclude entry and to jump

to option "group".

A measurement to be stored, can also be stored under an existing name. To do

this, you have to specify a different group or valve number.

Group

Numerical values up to 999 can be entered here.

Press key "OK" to conclude entry.

Number

Numerical values up to 999 can be entered here.

Press key "OK" to conclude entry.

Printing of valve data

This option of the menu permits the output of the measured values via a PC.

To do so, the measurements carried out must have been stored in the flow

meter by using the command "Store". Up to 199 measurements may be stored

and transmitted to the PC subsequently.

In order to do this, the transmission cable has to be connected to the flow

meter and the USB interface. After having selected "Receiving data" on the PC,

the programme is waiting for the data of the "OV-DMC 2". To do this, choose

the submenu "Print content" within the menu "System-Setup" and start data

transfer by pressing the key "OK" on the flow meter.