Operating Mode 'Custom; Check The Job - Rapid Shape RS wash Operating Instructions Manual

Operating instructions RS wash │ D wash │ P wash │ SHERAprint wash │ 3Dewash
6.4.3 Operating Mode ‚Custom'
6.5

Check the job

Rapid Shape GmbH │ DOCR000257
The cleaning parameters (e.g. the cleaning time) are
selected based on the print job.
For safety reasons, the machine should not be opened
during the cleaning process.
In ‚Custom' mode, you can create your own parameter sets.
For the proper cleaning of the component, observe the
specifications of the material manufacturer when
creating custom parameters. Only by observing the
instructions of the manufacturer can safe
biocompatibility be ensured.
For safety reasons, the machine should not be opened
during the cleaning process.
After the cleaning process, check the component for the desired result:
1. Open the drawer.
2. Remove the components.
3. Close the drawer.
4. Check the components
If you notice that the curing result deviates from the
desired result, please repeat the workflow or contact
Customer Service.
22 │ 29