Table of Contents
Advertisement
Operating instructions RS wash │ D wash │ P wash │ SHERAprint wash │ 3Dewash
6.4
Select operating mode & start
6.4.1 Operating Mode ‚Jobs'
Rapid Shape GmbH │ DOCR000257
The components must not overlap each other.
The maximum filling level must not be exceeded, see
marking on the infeed grid.
If you used a disposable building platform for printing,
place the building platform in the appropriate capsule
insert.
If you want to clean a building platform, place it flat
side down in the inner container.
Hollow models must be separated from the building
platform due to their mechanical properties prior to the
cleaning process. For an optimum drying result we
recommend inserting hollow models with the cavities
downwards.
To start the cleaning process, you can choose from the following three
operating modes:
— Operating mode ‚Jobs' → Chapter 6.4.1
— Operating mode ‚Material' → Chapter 6.4.2
— Operating mode ‚Custom' → Chapter 6.4.3
In the 'Jobs' operating mode, the cleaning process is performed based
on the print job submitted. To start the process, please proceed as
follows:
1. Prerequisites: There is a connection between the cleaning unit
and the 3D printer. → Chapter 4.3.3
The inner container is properly equipped. → Chapter 6.3
2. Go to Home screen.
3. Select the ‚Jobs' tab.
4. Select the respective print job.
5. Press the 'Start' button. The cleaning process starts, the current
progress is shown on the display.
20 │ 29
Advertisement
Table of Contents
