Operating Mode 'Material - Rapid Shape RS wash Operating Instructions Manual

6.4.2 Operating Mode ‚Material'
21 │ 29
Operating instructions RS wash │ D wash │ P wash │ SHERAprint wash │ 3Dewash
Figure 4: Home screen, job selection
The cleaning parameters (e.g. the cleaning time) are
selected based on the print job.
For safety reasons, the machine should not be opened
during the cleaning process.
In the 'Material' operating mode, the cleaning process is performed
based on the materials used. To start the process, please proceed as
follows:
1. The inner container is properly equipped. → Chapter 6.3
2. Go to Home screen.
3. Select the ‚Material' tab.
4. Select the respective material you used when printing the
components.
5. Press the 'Start' button. The cleaning process starts, the current
progress is shown on the display.
Figure 5: Selection of materials
Rapid Shape GmbH │ DOCR000257