Table of Contents
Advertisement
Care and Maintenance
WARNING : To avoid personal injury, always shut off and unplug the unit and relieve all air pressure
from the system before performing.
Regular maintenance will ensure trouble-free operation.
To prevent corrosion inside the tank, the condensation must be
drained at the end of every workday. Be sure to wear protective
goggles. Relieve the air pressure in the system and then open the
Drain the
drain valve on the bottom of the tank.
tank
Pull the relief valve on the ring daily to ensure that it is
operating properly and to clear the valve of any possible
Check the
obstuctions.
relief valve
Check all connections to see if tight. A small leak of any of part
(the tank, hoses, pipe connections or transfer tubes) will reduce
Test for
the unit's performance.
leakage
Spray a small amount of soapy water around the area of the
suspected leak with a spray bottle. If bubbles appear, repair or
replace the faulty component. Do not over tighten any connections.
Before storing the unit for a long period, use an air blow gun to
clean all dust and debris from the compressor. Disconnect and coil
the power cord up. Pull the pressure relief valve to release all
Storage
pressure from the tank. Drain all moisture from the tank. Cover
the entire unit to protect it from moisture and dust.
10
CLOSE
OPEN
BRIGGSandSTRATTON.COM
Advertisement
Table of Contents
