Aeotec 7 Pro User Manual page 8

Size: 1 Byte
Default Value: 0
Description:
This is the BASIC command value sent in case of Off event.
0 - 99 - Value
255 - On
9. Time Delay of On command frame
Parameter: 9
Size: 2 Byte
Default Value: 0
Description:
On command is sent after a delay defined in this parameter.
0 - 32400 - Seconds
10. Time delay of Off command frame
Parameter: 10
Size: 2 Byte
Default Value: 0
Description:
Off command is sent after a delay defined in this parameter.
0 - 32400 - Seconds
11. Delay of tamper alarm cancellation.
Parameter: 11
Size: 2 Byte
Default Value: 0
Description:
Time a tamper alarm is delayed.
0 - 32400 - Seconds
12. Reporting tamper alarm cancellation
Parameter: 12
Size: 1 Byte
Default Value: 1
Description:
This parameter defines if the alarm cancellation event is reported.
0 - do not send report
1 - send report
16. Minimum Temperature change to report.
Parameter: 16
Size: 1 Byte
Default Value: 20
Description:
This value defines the minimum change of temperature to cause an unsolicited report of humidity to the central
controller using Lifeline. If the value is set to 0, there will be no reports sent to the controller, when the temperature
changes. However, periodic reports, managed by configuration parameter 18, may still be active.
0 - disabled
1-100 - 0,1 degree step
17. Minimum humidity change to report.