JVC KD-SH909 Instructions Manual page 33

To select the subwoofer cutoff frequency
– CUT OFF F
When a subwoofer is connected to this unit,
select an appropriate cutoff frequency level for
your subwoofer.
When shipped from the factory, the subwoofer
cutoff frequency is set to "MID(80Hz)."
• LOW(50Hz): Frequencies higher than 50 Hz
are cut off to the subwoofer.
• MID(80Hz): Frequencies higher than 80 Hz
are cut off to the subwoofer.
• HIGH(115Hz): Frequencies higher than 115
Hz are cut off to the subwoofer.
To change the AM/FM channel intervals
– AREA
When this unit is shipped from the factory, the
channel intervals are set to 10 kHz for AM and
200 kHz for FM (AREA US settings).
You will have to change the channel intervals
when using this unit in an area other than North
America and South America.
• AREA EU: Select this when using this unit in
an area other than North and
South America. (9 kHz for AM
and 50 kHz (for manual tuning) /
100 kHz (for searching) for FM)
• AREA US: Select this when using this unit in
North or South America. (10 kHz
for AM and 200 kHz for FM)
Note:
If the channel intervals settings are changed, the
names assigned to the stations will be erased from
memory. To reassign the names, see "Assigning names
to the sources" on page 35.
To select the external component to use
–
EXT IN (For KD-SH707 only)
You can connect the external component to the
CD changer jack on the rear using the Line Input
Adaptor KS-U57 (not supplied).
To use the external component as the playback
source through this unit, you need to select which
component — CD changer or external
component — to use.
When shipped from the factory, "CD CHANGER"
is selected as the external component.
• CD CHANGER: To use the CD changer.
• LINE INPUT: To use the external component
other than CD changer.
Note:
For connecting the Line Input Adaptor KS-U57 and the
external component, refer to the Installation/
Connection Manual (separate volume).
To turn the line input switch on or off
– LINE IN (For KD-SH909 only)
You can switch the line input off when no external
component is connected to the LINE IN plugs.
When shipped from the factory, the line input
switch is set to "ON."
• ON: You can select "LINE INPUT
(LINE)" as the playback source.
• OFF: You cannot select "LINE INPUT
(LINE)" as the playback source.
33