Installing The System Software - Ricoh E-25C Field Service Manual

Installing the System Software

Install the system software in either of the following methods:

Network Installation (via Network Cable)

USB Installation (via USB flash drive)
Bootable USB flash driving containing the system software is required.
Network Installation (via Network Cable)
Complete the procedure of "Preparation at the Customer Site". [Link To
1.
Customer Site]
Remove all the USB devices that may be connected to the E-25C.
2.
Power on the Windows PC and do the following:
3.

Start the Fiery Installer Builder. (Double-click the Fiery Installer Builder icon on the desktop.
You can also click Start > EFI > Fiery Installer Builder)

Close all software applications except the Fiery Installer Builder.

Remove any network cables between the Windows PC and the customer network.

Disable all power-save and hibernation settings.

Stop all File Transfer Protocol (FTP) and Trivial File Transfer Protocol (TFTP) services.

Disable all anti-virus and anti-spyware programs.

Make sure that the PC is configured to obtain its IP address automatically (DHCP).

Disable all wireless network connections.

It is also recommended to disable the network adapter(s) on the client PC that will not be
used for the connection to the E-25C in the following steps. (For the procedure on how to
disable/enable the network adapter, refer to the Windows help.)

Turn off the Windows Firewall.

Remove all USB devices that may be connected to the E-25C.
At the Downloaded window of the Fiery Installer Builder, select Color Controller E-25C 1.0.
4.
From the Preparation action list, select Perform Network installation.
5.
Read the instructions in the windows and click Next.
6.
Shut down the E-25C [Link To
7.
Remove all external cables from the E-25C, except the power cable.
8.
Be sure to leave the power cable connected between the E-25C and the power outlet.
Shutting Down the E-25C
4.System Maintenance
Preparation at the
Only].
99