Dhcp; Dhcp Settings - TP-Link TL-WR843N User Manual


Note:
The range of bandwidth for Guest Network is calculated according to the setting of Bandwidth
Control on the page "Bandwidth Control->Control Settings".

DHCP

Figure 4-30 The DHCP menu
There are three submenus under the DHCP menu (shown in Figure 4-29): DHCP Settings, DHCP
Client List and Address Reservation. Click any of them, and you will be able to configure the
corresponding function.

4.9.1 DHCP Settings

Choose menu "DHCP → DHCP Settings", you can configure the DHCP Server on the page as
shown in Figure 4-30.The Router is set up by default as a DHCP (Dynamic Host Configuration
Protocol) server, which provides the TCP/IP configuration for all the PC(s) that are connected to
the Router on the LAN.
DHCP Server - Enable or Disable the DHCP server. If you disable the Server, you must have

another DHCP server within your network or else you must configure the computer manually.
Start IP Address - Specify an IP address for the DHCP Server to start with when assigning

IP addresses. 192.168.0.100 is the default start address.
End IP Address - Specify an IP address for the DHCP Server to end with when assigning IP

addresses. 192.168.0.199 is the default end address.
TL-WR843N 300Mbps Wireless AP/Client Router User Guide
Figure 4-31 DHCP Settings
- 55 -