Menu Item Details - Sharp PN-E703 Operation Manual

Menu item details

The menu will differ depending on the input mode.
nSCREEN
You can move the menu screen display position each time
AUTO (D-SUB[RGB]/DVI-I (analog))
The CLOCK, PHASE, H-POS, and V-POS are automatically adjusted.
ENTER
Pressing performs adjustment. Use this automatic adjustment when you use the D-SUB[RGB] or DVI-I (analog) to display
a PC screen for the first time or when you change the setting of the PC. (See page 31.)
CLOCK (D-SUB[RGB]/DVI-I (analog))
Adjusts frequency for sampling clock for applicable video.
Adjust when there is flickering in the form of vertical stripes.
When using the adjustment pattern (see page 31), make adjustments so that no vertical stripe noise appears in it.
PHASE (D-SUB[RGB]/DVI-I (analog))
Adjusts sampling clock phase for applicable video. Useful when small characters appear with low contrast and/or there are
flickers at corners. When using the adjustment pattern (see page 31), make adjustments so that no horizontal stripe noise
appears in it.
* Adjustments to PHASE should be made only after CLOCK has been correctly set.
H-POS
Adjust the horizontal position of the image.
V-POS
Adjust the vertical position of the image.
H-SIZE
Adjust the horizontal size of the image.
V-SIZE
Adjust the vertical size of the image.
RESOLUTION SETTING (D-SUB[RGB]/DVI-I (analog))
H-RESOLUTION
Sets proper horizontal resolution when the resolution of input signals is not recognized properly.
(Adjustment may be impossible with some signals.)
V-RESOLUTION
Sets proper vertical resolution when the resolution of input signals is not recognized properly.
(Adjustment may be impossible with some signals.)
INPUT SIGNAL (D-SUB[RGB]/DVI-I (analog))
If a computer connected to the D-SUB[RGB]/DVI-I (analog) outputs any of the following resolutions, make a selection from the
following options.
480 LINES .......... AUTO, 640x480 or 848x480
768 LINES ..........AUTO, 1024x768, 1280x768, or 1360x768
1050 LINES ........1400x1050 or 1680x1050
ZOOM2 SPECIAL SETTING (See page 29.)
RESET
Resets the values of the SCREEN menu items to the factory preset values.
Select "ON" and then press
ENTER
.
DISPLAY
is pressed.
Menu Items
21
E