Removal - Doosan DX140R Shop Manual

REMOVAL

1. Look at fuel level display (Figure 2) on instrument panel in
operator's cabin to see what it displays. The display is
divided into ten separated segments, each representing 10
percent of total fuel supply. Also, look at level gauge on
side of tank to estimate volume of fuel left in tank.
NOTE:
If possible, work excavator until available fuel
supply in tank has been run down as far as
possible.
2. Park on firm and level ground and swing turntable to
approximately a 90° with respect to tracks. See Figure 3.
3. Lower front attachment (bucket) to ground.
4. Shut down engine.
5. Set safety lever on "RELEASED" position.
6. Turn starter switch to "I" (ON) position.
If engine must be run while performing maintenance,
use extreme care. Always have one person in the
cabin at all times. Never leave the cabin with the
engine running.
7. Fully stroke work levers (joysticks) in all directions to
relieve any pressure from accumulators.
8. Set safety lever on "LOCK" position.
9. Turn key to "O" (OFF) position and remove from starter
switch.
10. Hang maintenance warning tag on controls.
11. Disconnect negative (-) battery cable leading to frame from
battery.
Fuel Tank
Page 8
WARNING
E
Figure 2
Figure 3
O
I
WARNING
when performing inspection
190-00695A
Figure 4
F
FG014483
FG000471
FG014348
SP001940