Operate The Keypad - Kohler K-1167 Installation Manual

Air Flow Mode
Activates Mode Selected
Rotate Outer Ring to
Access Desired Mode
Power On/Off
Chromatherapy Specific
Color (if provided)

15. Operate the Keypad

Available modes/features will be illuminated in blue. Active modes will be illuminated in green.
Power ON/OFF
Outer Ring
OK
Air Flow Mode
Zone 1
Zone 2
Zone 3
Surge Mode
UP Arrow
Indicator Bar
DOWN Arrow
Purge Mode
Sleep Mode
1167629-2-A
Zone 1
Turns the blower motor ON and OFF.
Rotate the outer ring to the desired mode. The selected mode
will flash blue.
Activates the desired mode. The active mode will flash green.
Air flow is directed through any combination of the airjets in the
selected zones. Adjust the air flow with the arrow buttons. When
the surge mode is selected, the air flow mode stops. When the air
flow mode is selected while operating in the surge mode, the
surge mode stops.
Selects or deselects the air flow through Zone 1.
Selects or deselects the air flow through Zone 2.
Selects or deselects the air flow through Zone 3.
When active, the air flow ramps up from minimum to maximum
and then down again to minimum. Adjust the surge speed
between 10 seconds and 60 seconds by using the UP or DOWN
arrows. Select or deselect zones when in the surge mode.
Increases the air flow when the air flow mode is active. Increases
the pulse speed when the surge mode is active.
Shows the air flow volume when operating in the air flow mode.
Shows the surge speed when operating in the surge mode.
Decreases the air flow when the air flow mode is active.
Decreases the pulse speed when the surge mode is active.
Select to initiate the purge mode manually. The purge cycle will
not start if there is water in the bath. The purge mode blows any
residual water out of the air harness. The blower motor starts
and runs at a low speed for about 2 minutes. An automatic purge
cycle occurs when the bath is drained and the water level falls
below the level sensors.
To enhance your bathing experience, the keypad is programmed
to darken after approximately 15 seconds of inactivity. Only the
last feature selected will remain illuminated. To resume normal
operation, press any key or turn the outer ring. Approximately 1
minute after all equipment is turned off, the keypad will darken
completely to conserve power. Press the Power button or turn the
outer ring to reactivate the keypad.
Zone 2
Zone 3
Surge Mode
Chromatherapy Cycle (if provided)
Purge Mode
22
Increase Flow or Surge
Indicator Bar
Decrease Flow or Surge
Kohler Co.