Kohler K-1167 Installation Manual page 20

Test Run the Bath (cont.)
When the water level drops below the level sensor probes, verify that the blower starts at low
speed.
After about 2 minutes, verify that the blower motor stops.
Operate the Manual Purge Cycle
With the bath drained, rotate the outer ring to the purge cycle icon.
Press the "OK" icon.
Observe that the blower starts in the purge cycle. Residual water will blow out from the air harness.
After the blower has operated for about 2 minutes, observe that the blower stops.
Place the protective drop cloth over the bath.
Turn off the power to the bath.
1167629-2-A 20 Kohler Co.