Assembly Instructions - Kobalt KSP 1024B-03 Manual

ASSEMBLY INSTRUCTIONS

1. To Install/Remove Battery Pack
To Attach Battery Pack
a. Make sure that the ON/OFF switch (B) is in the
OFF position.
b. Align the raised portion on the battery pack
with the grooves on the bottom of the tool, and
then slide the battery pack onto the tool as
shown.
c. Ensure that the battery-release buttons on the
battery pack snap into place and the battery
pack is secured to the tool before beginning
operation.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack aligns with the groove on the tool and the
latches snap into place properly. Improper assembly of the battery pack can cause damage to
internal components.
To Detach Battery Pack
a. Make sure that the ON/OFF switch (B) is in OFF position.
b. Press the battery-release buttons to release the battery pack.
c. Pull backward on the battery pack to remove it from the tool.
WARNING
Battery tools are always in operating condition. Therefore, the ON/OFF switch should always in
OFF position when the tool is not in use or when carrying the tool at your side.
Battery Pack Protection
To protect the life of the battery pack, the sprayer will shut off when the battery's charge
becomes too low. If this happens, remove the battery pack and charge it according to the
charger's instructions.
2. Connecting the Spray Wand to the Handle
a. Make sure the O-ring in the end cap is in
place.
b. Thread the end cap of the spray wand (H) onto
the handle and tighten it securely.
c. Rotate the end cap to extend to desired length
and tighten securely.
1
2a
End cap
9
Battery-
release
button