Table of Contents
Advertisement
4.0 Operation
4.1
Control Panel
1
4
4.3 Operating instructions
The machine needs to be placed in a well-
ventilated area ensuring that the air vents are
not covered.
For Flux-cored Welding.
1 Ensure correct personal protective equipment
is worn and that fume extraction and other
correct welding safety procedures are in place
before you begin.
2 Load your 1kg shelf-shielded wire according to
instructions found in 3.1.
3 Turn power on at the outlet (there is no on/off
switch on the machine).
4 Set the wire speed and voltage using the
welding power knob [1].
5 Begin welding.
12
1
Welding power knob
2
Power indicator
2
3
Fault indicator
3
4
Fixed welding torch lead*
5
Fixed work return lead*
6
Power lead
The illustrations shown here are
indicative only. The actual product
may differ slightly.
5
4.2 Back Panel
IMPORTANT –
THERMAL PROTECTION
When the operation time of the machine
exceeds the rated duty cycle, the machine
may suddenly stop working due to
overheating. If this happens the red light on
the front of the machine panel will illuminate.
It is important to leave the machine switched
on so that the fans can continue to cool the
machine down. When the red light turns
off the machine will, once again, be ready
for welding.
6
INPUT
AC 240V
Advertisement
Table of Contents
