Advertisement
Figure 1
Multi Pro 1750 and Multi Pro 5800
1. Flanged locknut (Multi Pro
1750—3/8 inch; Multi Pro
5800—5/16 inch)
2. Hose hook
3. Carriage bolt (Multi Pro
1750—3/8 x 3/4 inch; Multi
Pro 5800—5/16 x 1 inch)
4. Front, right tank strap
•
For the Multi Pro WM, loosen the rear, right strap
(Figure
2).
5. Carriage bolt (5/16 x 3/4
inch)
6. Spray-gun bracket
7. R-clamp
8. Flanged locknut (5/16
inch)
1. Flanged locknut (5/16
inch)
2. Hose hook
3. Carriage bolt (3/8 x 3/4
inch)
4. Rear, right tank strap
2. Install the R-Clamps, spray-gun bracket, and hose hook
as shown in
Figure 1
flat washer, and flange-head nut.
3
Installing the Shutoff Valve
(Multi Pro 1750 and Multi Pro
WM only)
Parts needed for this procedure:
1
Female cap
1
Shutoff valve
Procedure
1. Remove the retainer that secures the a actuator to the
manifold valve for the section valve or agitation valve
(Figure
3).
3
Figure 2
Multi Pro WM
5. Carriage bolt (5/16 x 3/4
inch)
6. Spray-gun bracket
7. R-clamp
or
Figure 2
using a carriage bolt,
Advertisement
