Advertisement
4
Installing the Spray-Gun Valve
Parts needed for this procedure:
1
Spray-gun valve
1
Hose-reel supply hose
1
Flange clamp
1
Gasket
1
Fitting, 90-degree
1
Hose clamp
Procedure
1. Remove the flange clamp that secures the endcap and
coupler at the pressure-gauge port
8).
Multi Pro 1750 and Multi Pro WM
1. Gasket
2. 90-degree fitting
3. Gasket clamp
(Figure 7
or
Figure 7
4. Coupler
5. Control valve
6. Hose-reel supply hose
g028390
Figure
1. Gasket
2. 90-degree fitting
3. Flange clamp
2. Remove the coupler from the endcap
Figure
8).
3. Install the control valve assembly as shown in
or
Figure
4. Install the coupler into the open port on the 90-degree
fitting
(Figure 7
Note: The port in the side of the 90-degree fitting for
the Multi Pro 1750 and Multi Pro WM is at the forward
side (not shown) of the fitting in
5. Connect the hose-reel supply hose to the control valve
using a hose clamp
5
Figure 8
Multi Pro 5800
4. Coupler
5. Control valve
6. Hose-reel supply hose
8.
or
Figure
8).
Figure
(Figure 7
or
Figure
(Figure 7
and
Figure 7
7.
8).
Advertisement
