Panel Mounting - nVent RAYCHEM TCONTROL-05 Manual

It is also possible to mount the device holder with its front
positioned horizontally so that the connection terminals
can be accessed from the front. After connection, the device
holder must be removed from this position!
5. Insert the device holder into the side recesses of the base
plate with its rear detent lugs and press down until it
engages.
2.5

Panel mounting

TCONTROL-05
1. Insert the device from the front into the panel cut-out and
ensure that the seal is correctly positioned.
2. Push the mounting frame from the panel rear onto the
device body and press the springs against the panel rear until
the detent lugs engage in their slots and the
frame is sufficiently fastened.
CAUTION!
The front of the device and housing have different protection
types!
The protection type IP65 (front-side) is only guaranteed if the seal
is flush and even.
 Use the mounting frame or both mounting elements as shown
in the figure and ensure an even attachment!
1.
2.
nVent.com/RAYCHEM | 13