Mounting; Installation Site And Ambient Conditions; Cleaning - nVent RAYCHEM TCONTROL-05 Manual

2.

Mounting

2.1

Installation site and ambient conditions

WARNING!
The device is not designed for use in potentially explosive areas.
Explosion hazard.
 Only deploy the device outside of potentially explosive areas.
Mounting site
The device is designed for installation in a panel cut-out within a
closed switch cabinet. The front of the device and housing have
different protection types (see technical data).
Climatic conditions
The ambient temperature and the relative humidity at the
mounting site must correspond to the technical data. Aggressive
gases and vapors have a negative effect on the operating life of
the device. The mounting site must be free from dust, powder,
and other suspended solids.
Installation position
The device can be installed in any position.
The maximum admissible ambient temperature only applies for
the installation with the display in a vertical position.
Technical data
chapter 5 "Technical data", Page 24
2.2

Cleaning

The front of the device (front foil) can be cleaned with standard
detergents, rinsing and cleaning agents.
CAUTION!
The front of the device is not resistant to aggressive acids and
lyes, scouring agents, and cleaning with a pressure cleaner.
Use of these media can cause damage.
 Only clean the front of the device with suitable agents.
nVent.com/RAYCHEM | 11