Dimensions; Din Rail Installation - nVent RAYCHEM TCONTROL-05 Manual

2.3

Dimensions

TCONTROL-05
Panel cut-out according to DIN IEC 61554
TCONTROL-05
dimensions
48 mm × 48 mm
2.4

DIN rail installation

Special mounting elements for mounting on a DIN rail (35 mm,
according to DIN EN 60715) are available as accessories. This
involves a base plate attached to the DIN rail and a device holder
(see depictions in the section "Dimensions").
Process:
1. Mount the base plate on the DIN rail from above and press
down until it engages.
2. Insert the mounting frame (included in the scope of delivery
of the device, see Panel mounting) into the device holder
from above (front).
3. Insert the device (without panel seal) into the device holder
from the front and secure using the mounting frame. In doing
so, ensure sufficient attachment (see Panel mounting).
4. Carry out electrical connection.
To facilitate the connection, the device holder can be
mounted in the base plate from above with its underside
positioned vertically (top connection terminals).
12 | nVent.com/RAYCHEM
77.9
4.8
Panel cut-out
(width x height)
45 mm × 45
+0.6
Minimum spacing of panel
cut- outs (for tightly packed
installations)
Horizontal
mm 15 mm
+0.6
48
Vertical
30 mm